#KEYPAD LOCK HOW TO#
#KEYPAD LOCK INSTALL#

You’ll need to remove the lock from the door and install it. Your Schlage Keypad Lock may develop issues, such as spinning, not locking/unlocking if it’s not installed properly. If the problem persists after the reset, the lock might have been installed wrongly. If this method doesn’t reset your lock, read more about resetting a Schlage keypad Lock. This step should be completed in 10 seconds.

Then press and hold the Schlage button until you see a green light, and the lock beeps. Remove the battery cover and disconnect the battery.

#KEYPAD LOCK HOW TO#

See how to find your Schlage Keypad Lock default Programming Code. This usually helps to fix problems caused by incorrect settings or internal glitches.īut before you reset your lock, look for the default Programming Code, as you’ll need it to program your lock after the reset. Resetting the lock will erase all settings in your lock and restore the default settings. Restore Default Settings on the LockĪnother fix to try if your Schlage Keypad Lock keeps spinning is to reset the lock. If your Schlage Keypad keeps spinning after replacing the batteries, continue to the next step. Sometimes, the batteries in your lock may drain out quickly without the usual warnings-probably because the batteries are bad or because of cold. However, if you don’t see red flashes on the lock, you should still go ahead and replace the batteries. For Schlage BE365, get a 9V battery and replace the old one. If you see red flashes on your lock, get a new set of batteries and replace the old ones. Your Schlage Keypad lock will blink red consistently when the batteries are low. The lock is battery-powered, so it may develop some issues if the batteries are low.įor this issue, the motor of the lock may not have sufficient power to engage the mushroom pin fully-because the battery power is low.

If your Schlage Keypad Lock keeps spinning, start your troubleshooting by replacing the batteries in the lock. Tips to Fix a Schlage Keypad Lock that Keeps Spinning 1. This should resolve the problem.įor more details on how to go about this issue, keep reading. If that doesn’t help, perform a factory reset on the lock. In short, if your Schlage Keypad Lock keeps spinning, replace the batteries. In the following paragraphs, I’ll walk you through some handy tips to troubleshoot this issue. If your Schlage Keypad Lock won’t stop spinning and you’re looking for tips to resolve this problem, this post is your go-to resource.